Table of Contents
This is an old revision of the document!
TCB Installation
This section will describe how to install the TCB and hook up all the various accessories.
Topics
In addition to the TCB, at a minimum you will also need a speed controller for the drive motors, and a PPM, SBus, or iBus capable receiver. Please read through all the hardware installation topics in the menu at left.
Short Warning!
Note: There are exposed pins on the bottom of the TCB board! Do not install the TCB on top of a metal plate or you will short something!
Board Dimensions
The TCB board has four mounting holes sized for 3mm or 4-40 screws.
TCB Board Dimensions (PDF) Make sure you set Page Scaling = None when you print!
