Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
wiki:tcb:tcbinstall:smoker [2019/09/04 02:38]
opadmin [Smoker]
wiki:tcb:tcbinstall:smoker [2019/09/04 02:38] (current)
opadmin [Smoker]
Line 7: Line 7:
 For people wanting to create their own smokers, the SMOKER output supplies battery voltage at up to 3 Amps (the maximum current rating of the JST-XH connector, the MOSFET can actually handle more). PWM is unidirectional at 31kHz (ultrasonic). ​ For people wanting to create their own smokers, the SMOKER output supplies battery voltage at up to 3 Amps (the maximum current rating of the JST-XH connector, the MOSFET can actually handle more). PWM is unidirectional at 31kHz (ultrasonic). ​
  
-You also have the option of controlling the smoker fan and heating element separately by selecting the **Separate** smoker type on the [[wiki:​opconfig:​tabs:​motors#​smoker|Motors tab]] of OP Config. Under this arrangement the fan needs to be plugged into the AUX output which the TCB will reserve for its use. The AUX output can only provide 5 volts so you should try to select a fan that will run at that level. The heating element will then be connected to the SMOKER output since it can handle more current. ​+You also have the option of controlling the smoker fan and heating element separately by selecting the **Separate** smoker type on the [[wiki:​opconfig:​tabs:​motors#​smoker|Motors tab]] of OP Config. Under this arrangement the fan needs to be plugged into the AUX output which the TCB will reserve for its use. The AUX output can only provide 5 volts so you should try to select a fan that will run at that level. The heating element will then be connected to the SMOKER output since it can handle more current ​(and it will obviously be driven at full battery voltage)
  
 On the [[wiki:​opconfig:​tabs:​motors#​smoker|Motors tab]] of OP Config you can specify the smoker'​s idle speed, fast idle speed (speed with transmission disengaged),​ and max speed, and if you are using separate heat and fan outputs you can control these levels individually and you will also be given the option to automatically pre-heat the heating element for a user-defined length of time before the engine starts. You can even "​disconnect"​ the smoker output from the engine effect, and re-purpose it as an electronic switch or unidirectional electronic speed control using the [[wiki:​tcb:​operation:​functionlist#​smoker|Smoker functions]]. ​ On the [[wiki:​opconfig:​tabs:​motors#​smoker|Motors tab]] of OP Config you can specify the smoker'​s idle speed, fast idle speed (speed with transmission disengaged),​ and max speed, and if you are using separate heat and fan outputs you can control these levels individually and you will also be given the option to automatically pre-heat the heating element for a user-defined length of time before the engine starts. You can even "​disconnect"​ the smoker output from the engine effect, and re-purpose it as an electronic switch or unidirectional electronic speed control using the [[wiki:​tcb:​operation:​functionlist#​smoker|Smoker functions]]. ​
wiki/tcb/tcbinstall/smoker.txt ยท Last modified: 2019/09/04 02:38 by opadmin