Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
wiki:tcb:tcbinstall:io_ports_ab [2017/07/24 02:30] opadmin [Using an I/O Port as Output] |
wiki:tcb:tcbinstall:io_ports_ab [2021/03/19 19:28] opadmin [Using an I/O Port as Output] |
||
---|---|---|---|
Line 31: | Line 31: | ||
===== Using an I/O Port as Output ===== | ===== Using an I/O Port as Output ===== | ||
- | When an I/O port is set to output, four functions appear in the [[wiki: | + | When an I/O port is set to output, four functions appear in the [[wiki: |
If you wish to connect the output to another microcontroller (such as another Arduino) you can do so directly - just connect the signal pin of the I/O port to the input pin of your other controller, and also make sure both the TCB and the other controller share a ground connection. | If you wish to connect the output to another microcontroller (such as another Arduino) you can do so directly - just connect the signal pin of the I/O port to the input pin of your other controller, and also make sure both the TCB and the other controller share a ground connection. | ||
Line 37: | Line 37: | ||
However keep in mind these outputs are only rated at 20mA each. That means they will almost surely be inadequate for driving lights, relays or other devices. For that you will need to add an external transistor or MOSFET circuit. A simple 2n2222 transistor circuit will work and there are many schematics on the internet. Or see the [[wiki: | However keep in mind these outputs are only rated at 20mA each. That means they will almost surely be inadequate for driving lights, relays or other devices. For that you will need to add an external transistor or MOSFET circuit. A simple 2n2222 transistor circuit will work and there are many schematics on the internet. Or see the [[wiki: | ||
- | There are also various logic-level modules available on eBay that can interface directly with the TCB using a male-to-male servo cable. But be careful when choosing them, because many use a different pinout than the TCB! They can still be used, but you will need to swap the pins on your servo cable. The order on the TCB is Ground/ | + | There are also various logic-level modules available on eBay that can interface directly with the TCB using a male-to-male servo cable. But be careful when choosing them, because many use a different pinout than the TCB! They can still be used, but you will need to swap the pins on your servo cable. The order on the TCB is Ground/ |
==== Relay Modules ==== | ==== Relay Modules ==== | ||
- | Five volt relay modules with a logic-level trigger abound on eBay and are very inexpensive. Most do not use the same pinout as the TCB. Two that do are the [[http:// | + | Five volt relay modules with a logic-level trigger abound on eBay and are very inexpensive. Most do not use the same pinout as the TCB. Two that do are the **Keyestudio |
With a relay module you can switch on or off a high-current device or a device that uses a different voltage source from the TCB entirely. | With a relay module you can switch on or off a high-current device or a device that uses a different voltage source from the TCB entirely. | ||
{{ wiki: | {{ wiki: | ||
- | < | + | < |
\\ | \\ | ||
{{ wiki: | {{ wiki: | ||
- | < | + | < |
\\ | \\ | ||