Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
wiki:tcb:operation:functionlist [2020/07/30 13:03] opadmin [RC Passthrough] |
wiki:tcb:operation:functionlist [2021/03/22 23:43] opadmin [General Purpose Outputs A & B] |
||
|---|---|---|---|
| Line 210: | Line 210: | ||
| ===External Output A | B - On | Off | Toggle | Pulse | Blink (D)=== | ===External Output A | B - On | Off | Toggle | Pulse | Blink (D)=== | ||
| - | The **On** function will turn Output A on, the **Off** function will turn it off, and the **Toggle** function will toggle the Output A status (on → off, off → on). The **Pulse** function will briefly set the pin to the opposite state of its default level (default level set in OP Config, either High or Low). Use the Pulse function to emulate a button press to some external device. The **Blink** function will start blinking the output at the rate specified on the [[wiki: | + | The **On** function will turn Output A on, the **Off** function will turn it off, and the **Toggle** function will toggle the Output A status (on → off, off → on). The **Pulse** function will briefly set the pin to the opposite state of its default level (default level set in OP Config, either High or Low). The pulse length can be specified on the [[wiki: |
| \\ | \\ | ||