Differences
This shows you the differences between two versions of the page.
| Both sides previous revision
Previous revision
|
Next revision
Both sides next revision
|
wiki:opconfig:tabs:radio [2016/04/03 03:48]
opadmin [General Information] |
wiki:opconfig:tabs:radio [2016/04/03 03:49]
opadmin [Radio Setup] |
| </li> | </li> |
| |
| <li><b>Deadband:</b> The 4 stick channels have an optional deadband setting. The radio signal is rarely ever completely steady even when you aren't touching the sticks. If the TCB responded to every small change in the signal, you may find your model creeping about when you thought it should be stopped. The Deadband setting is a way to overcome the issue of an unsteady signal. Any stick movement <i>less than</i> the deadband amount will be ignored. This number should be small, but greater than 0. Don't set it any larger than you need to - the greater the deadband, the more you will have to move your stick on purpose to get anything to happen. Watching the <b>Pulse</b> column while the radio is streaming will give you a good idea of the variability of your signal. PPM receivers will exhibit much more jitter than SBus. | <li><b>Deadband:</b> The 4 stick channels have an optional deadband setting. The radio signal is rarely ever completely steady even when you aren't touching the sticks. If the TCB responded to every small change in the signal, you may find your model creeping about when you thought it should be stopped. The Deadband setting is a way to overcome the issue of an unsteady signal. Any stick movement <i>less than</i> the deadband amount will be ignored. This number should be small, but greater than 0. Don't set it any larger than you need to - the greater the deadband, the more you will have to move your stick on purpose to get anything to happen. Watching the <b>Pulse</b> column while the radio is streaming will give you a good idea of the variability of your signal. PPM receivers will exhibit much more jitter than digital serial receivers. |
| </li> | </li> |
| |