Show page

Menu

Search

Random Fact

This Wiki has 49 million pages and took 10 years to write!
(Well, close...)

If you like the Open Panzer project we accept donations!

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision Both sides next revision
wiki:opconfig:tabs:firmware [2019/10/09 05:47]
opadmin [Update Firmware] 		wiki:opconfig:tabs:firmware [2019/10/09 05:52]
opadmin [Update Firmware]
Line 38: Line 38:
 **Scout ESC**\\ **Scout ESC**\\
 Before flashing your Scout, be sure to disconnect it from your TCB otherwise the operation may fail. The Scout does not have a built-in USB connection, instead you must use an FTDI adapter or FTDI cable. One end of the adapter/cable will have a six-pin socket that plugs into the six pins on the Scout. Be sure to orient it so the "Black" and "Green" labels on the adapter match the same labels printed on the bottom of the Scout board. The other end of the FTDI adapter/cable is a standard USB connection that you use to connect to your computer. Be sure you have selected the correct COM port in OP Config, then click the Flash button. The status of the flash operation will be shown in the console window. Before flashing your Scout, be sure to disconnect it from your TCB otherwise the operation may fail. The Scout does not have a built-in USB connection, instead you must use an FTDI adapter or FTDI cable. One end of the adapter/cable will have a six-pin socket that plugs into the six pins on the Scout. Be sure to orient it so the "Black" and "Green" labels on the adapter match the same labels printed on the bottom of the Scout board. The other end of the FTDI adapter/cable is a standard USB connection that you use to connect to your computer. Be sure you have selected the correct COM port in OP Config, then click the Flash button. The status of the flash operation will be shown in the console window.
 +
 +There are two versions of Scout firmware. Both have the same functionality but changes are required for different hardware revisions of the Scout board:
 +  * **Scout ESC (R11+):** For Scout board revisions from 11 forward (using the VNH5019 motor driver chips)
 +  * **Scout ESC (R10 and prior):** For Scout board revisions 10 and earlier (using the VNH2SP30 motor driver chips)
  
 **Open Panzer Sound Card**\\ **Open Panzer Sound Card**\\
wiki/opconfig/tabs/firmware.txt ยท Last modified: 2020/12/16 19:53 by opadmin
Show pageSitemap
AdminBack to top