Differences

This shows you the differences between two versions of the page.

--- wiki:opconfig:tabs:driving [2020/01/27 18:31]
opadmin [Track Recoil]
+++ wiki:opconfig:tabs:driving [2021/04/15 18:42]
opadmin [Freewheeling Gearboxes]
@@ Line 164: / Line 164: @@
 Also remember this option will only be enabled if the selected Vehicle Type on the Motors tab is set to Tank or Halftrack, and only if the Drive Motor type is set to Scout ESC.
+===== Onboard Red & Green LEDs for Troubleshooting =====
+{{ wiki:ledpatterns.jpg?direct&400|LED Key}}
+You can use the onboard Red and Green LEDs to verify that your board is responding properly to your radio. While driving, the Green LED indicates forward movement, the Red reverse movement, and both on at once indicate braking. The LEDs are off when stopped. When performing neutral turns, the Green LED blinks during turns to the right and the Red LED blinks during neutral turns to the left ([[wiki:opconfig:tabs:driving|if neutral turns are enabled]]). When not driving, a solid Red LED indicates the TCB is not in normal operation mode: either because it is still booting up, or because the user has entered a [[wiki:tcb:operation:specmenus|Special Menu]], or because it is paused in order to communicate with a PC. In Special Menus the Red LED will remain solid and the Green LED may blink to indicate certain information or steps. When communicating with the PC, the Red LED will remain solid and the Green LED will blink slowly.

wiki/opconfig/tabs/driving.txt · Last modified: 2023/06/04 17:26 by opadmin

Driving