TCB Installation

This section will describe how to install the TCB and hook up all the various accessories.


In addition to the TCB, at a minimum you will also need a speed controller for the drive motors, and a PPM, SBus, or iBus capable receiver. Please read through all the hardware installation topics in the menu at left.

Short Warning!

Note: There are exposed pins on the bottom of the TCB board! Do not install the TCB on top of a metal plate or you will short something!

Board Dimensions

The TCB board has four mounting holes sized for 3mm or 4-40 screws.

TCB Board Dimensions (PDF) Make sure you set Page Scaling = None when you print!

TCB Dimensions

wiki/tcb/tcbinstall/start.txt ยท Last modified: 2022/02/10 21:40 by opadmin