Table of Contents
This is an old revision of the document!
Table of Contents
TCB Installation
This section will describe how to install the TCB and hook up all the various accessories.
In addition to the TCB, at a minimum you will also need a speed controller for the drive motors, and a PPM or SBus capable receiver. Here is a list of all the hardware installation topics:
Short Warning!
Note: There are exposed pins on the bottom of the TCB board! Do not install the TCB on top of a metal plate or you will short something!
Board Dimensions
The TCB board has four mounting holes sized for 3mm or 4-40 screws.
TCB Board Dimensions (PDF)
Make sure you set Page Scaling = None when you print!