Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
wiki:tcb:tcbinstall:sound_benedini_v3 [2019/09/05 03:20] opadmin [Diagnostic / Misc Tab] |
wiki:tcb:tcbinstall:sound_benedini_v3 [2019/12/14 14:49] opadmin [Engine Sounds] |
||
|---|---|---|---|
| Line 12: | Line 12: | ||
| The TCB has three RC outputs dedicated to the Mini. They are labeled Prop1, Prop2, and Prop3 which are the same labels used on the Mini. | The TCB has three RC outputs dedicated to the Mini. They are labeled Prop1, Prop2, and Prop3 which are the same labels used on the Mini. | ||
| - | Note that the Mini has //two// Prop 1 connections, | + | Note that the Mini has //two// Prop 1 connections, |
| Use male-to-male servo cables for the connection. The TCB will supply all the power necessary to the Mini. | Use male-to-male servo cables for the connection. The TCB will supply all the power necessary to the Mini. | ||
| Line 76: | Line 76: | ||
| The other settings in TBS Flash you can set as you like and are not discussed here. When you have the Parameter tab configured as shown above, make sure you click the **write Param** (Flash v4) or **Write Device** (Flash v3) button to save these settings to your Mini. It is also recommended you save a copy of the parameter file to your hard-drive for backup. | The other settings in TBS Flash you can set as you like and are not discussed here. When you have the Parameter tab configured as shown above, make sure you click the **write Param** (Flash v4) or **Write Device** (Flash v3) button to save these settings to your Mini. It is also recommended you save a copy of the parameter file to your hard-drive for backup. | ||
| + | |||
| + | |||