Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
wiki:opconfig:tabs:firmware [2020/09/02 18:58] opadmin [Update Firmware] |
wiki:opconfig:tabs:firmware [2020/09/02 19:02] opadmin [Update Firmware] |
||
---|---|---|---|
Line 17: | Line 17: | ||
== Get Latest Release == | == Get Latest Release == | ||
{{ wiki: | {{ wiki: | ||
- | Click here to check the OpenPanzer.org website for the latest firmware for the selected device. If a file is detected the version number will be displayed and the hex file will be downloaded to a temporary folder. It is highly unlikely you will download a version of the firmware that is older than the version you already have on your TCB, but it might be the same version, in which case flashing the update is unnecessary. You can always check which version of the firmware your TCB is presently running by connecting to the TCB and looking at the Serial Status label on the bottom left of the OP Config program (#8 on the [[wiki: | + | Click here to check the OpenPanzer.org website for the latest firmware for the selected device. If a file is detected the version number will be displayed and the hex file will be downloaded to a temporary folder. It is highly unlikely you will download a version of the firmware that is older than the version you already have on your TCB, but it might be the same version, in which case flashing the update is unnecessary. You can always check which version of the firmware your TCB is presently running by connecting to the TCB and looking at the Serial Status label on the bottom left of the OP Config program (#8 on the [[wiki: |
== Use Your Own Hex == | == Use Your Own Hex == | ||
- | If you are a developer and have compiled your own hex, you can select it using this button. If you are working on a project in the Arduino IDE, you can generate a hex file by typing Ctrl+Alt+S or going to the Sketch menu and selecting the " | + | If you are a developer and have compiled your own hex, or perhaps were given a testing Hex by a developer on the Open Panzer forums, you can select it using this button. If you are working on a project in the Arduino IDE, you can generate a hex file by typing Ctrl+Alt+S or going to the Sketch menu and selecting the " |
== Flash == | == Flash == | ||
Line 39: | Line 40: | ||
\\ | \\ | ||
\\ | \\ | ||
+ | |||
+ | **TCB - Heclo Shield**\\ | ||
+ | Kim Olsen (username Heclo) designed a shield that when combined with a standard Arduino Mega board will provide all the functionality of the TCB, and then some. For more information on his design, [[http:// | ||
**Scout ESC**\\ | **Scout ESC**\\ | ||
Line 55: | Line 59: | ||
\\ | \\ | ||
- | **Generic ATmega328**\\ | + | **Generic ATmega328 |
- | You can use this setting | + | |
+ | You can use these selections | ||
+ | |||
===== Console Utility ===== | ===== Console Utility ===== |