[Tom]

At first I am going to use my Spektrum Dxi6 there is a little port for a PPM mini 3 pin connector
with Red/Black/Grey wires as shown in the jpg...In looking at the pins on the TCB is this correct?
(It looks like the + - are different than the pins on the TBC= signal positive negative)
Unless the inverted non inverted address this? In my orange receiver there is a little port
on the side but the mini cable is the same as shown. Thanks.

[LukeZ]

The Spektrum satellites are not supported. As always, read the Wiki first. It lists recommendations for compatible Spektrum receivers.

[Tom]

It is an "Orange RX DSM2" ?

[LukeZ]

The picture you attached is of a Spektrum Satellite receiver. They are not supported.

I don't know what model Orange receiver you have. Of the ones recommended in the Wiki, the Orange R615X does not have a port on the side. PPM is output using a standard servo plug (attached to the Batt/Bind slot) and the polarity is correct for the TCB.

If you have something else it's up to you to make sure it works.

[Tom]

Okay thanks Luke..looks like that but will get the exact one recommended.