Registration Notice

Due to increased spam, forum registration must be manually approved by a moderator! Please see this post for instructions.

Obsolete part
« on: May 17, 2022, 06:31:15 AM »
Hi,

Does anyone know if there is a replacement part for the below. Its the last part I need to complete my PCBs.

C14   S   5.3x5.3 mm (0.209")   Panasonic - ECG   CAP ALUM 10UF 35V 20% SMD   EEE-1VA100SR

Thanks

Steve

*

Offline jhamm

  • 140
  • It´s a hobby no profession!
    • View Profile
  • Germany
Re: Obsolete part
« Reply #1 on: May 17, 2022, 01:47:22 PM »
Hi Steve,
search for an electrolytic capacitor with the same data.
There are enough manufacturers who have something suitable on offer.
It doesn't have to be Panasonic.

*

Offline LukeZ

  • 1207
    • View Profile
  • France
Re: Obsolete part
« Reply #2 on: May 17, 2022, 04:15:50 PM »
Hi Steve, Jürgen is right, this is a pretty standard part and many manufacturers would make an equivalent.

I recall you're in the UK. I believe this one should work, available from Farnell UK, but they have others as well: Panasonic EEEHB1V100R
NO SUPPORT THROUGH PM - Read why
Need a forum account? Read here
Open Panzer FAQs

Re: Obsolete part
« Reply #3 on: May 18, 2022, 12:48:25 AM »
Hi,

Thanks for the help. Will be glad to get them finished so I can fit into my models.

Steve

*

Offline NS-21

  • 48
  • dreamer
    • View Profile
  • Russia
Re: Obsolete part
« Reply #4 on: May 18, 2022, 06:14:56 PM »
LukeZ, and what about tantalum capacitors in a plastic case?
Can they be applied? (naturally equivalent in characteristics).

For example 100*25V in SMD-D case? Used battery - Li-polymer 11.1V

I don’t like the capacitors that are in the original board model, or rather, I don’t like their soldering (the appearance is spoiled by a hot air soldering iron, as well as poor-quality soldering, since I don’t have a heated table), and I haven’t made a stove yet, or rather, no one has thrown away the kitchen a stove that can be converted for my projects.


*

Offline LukeZ

  • 1207
    • View Profile
  • France
Re: Obsolete part
« Reply #5 on: May 19, 2022, 06:37:13 AM »
Hi NS, yes a 10uF tantalum would work fine, in fact it is mentioned in the datasheet for the voltage regulator I use. If you use a different voltage regulator then you can check its datasheet for recommendations, but usually a tantalum will be fine.

An SMD-D will take up more space so it will not fit on the original board, but if you are making a new design then it doesn't matter.
NO SUPPORT THROUGH PM - Read why
Need a forum account? Read here
Open Panzer FAQs

 

bomber-explosion