Hi Luke,
I got my board from HK and I fixed the wrong mosfets Q1-Q8. I am trying to configure the TCB on the bench and almost all the features are working as expected, lights, etc. My only issue which is giving me fits is the servo recoil. I configured Aux3 as a 2-pos switch. Then in Triggers, I deleted the default Cannon Fire function and replaced it with a Cannon Fire function with Aux3 assigned as the trigger at Pos 2. In my Er9x, I assigned the TRN switch to Channel 7. In the Radio setup of OPConfig, I confirmed that Aux3 moves when the TRN switch is flicked and it does. Now my issue is, the servo recoil doesn't work when I flick the TRN switch. I have the box Trigger with Cannon checked under the servo recoil of the Motors section. Now if I delete the Cannon fire function and add a Recoil Servo function and configure it like the Cannon Fire and uncheck the Trigger with Cannon Fire box, the servo recoil works when I flick the TRN switch.
I am using the Taigen/HL high intensity flash. Do I need to do anything else to make it work apart from just plugging it into the right port? Does the recoil servo needs to be working before it is triggered and does it work if the function is Servo Recoil instead of the Cannon Fire?
The only other thing that does not work is the Cannon fire sound. I haven't checked my TBS mini config again but I was sure I assigned the cannon fire sound to Position 3 of the Parameters tab. All the engine sounds, turret traverse, barrel elevation and MG sounds work except the cannon fire. This sound should have been triggered by the Cannon Fire function, right? Servo Recoil function?
Thanks in advance,
Danny