TCB Installation

This section will describe how to install the TCB and hook up all the various accessories.

Topics

In addition to the TCB, at a minimum you will also need a speed controller for the drive motors, and a PPM, SBus, or iBus capable receiver. Here is a list of all the hardware installation topics:

Short Warning!

Note: There are exposed pins on the bottom of the TCB board! Do not install the TCB on top of a metal plate or you will short something!

Board Dimensions

The TCB board has four mounting holes sized for 3mm or 4-40 screws.

TCB Board Dimensions (PDF) Make sure you set Page Scaling = None when you print!


TCB Dimensions

wiki_ru/tcb/tcbinstall/start.txt · Last modified: 2017/11/12 23:46 by opadmin