This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - jhamm
Pages: 1 2 3 4 [5] 6 7 8 ... 10
61
« on: November 19, 2018, 02:21:17 AM »
Did you check the Channels on Radio Setup?
62
« on: November 19, 2018, 01:35:54 AM »
Hi,
did you set DRIVE MOTORS to RC-Output ?
63
« on: November 04, 2018, 11:43:01 PM »
For sure I do know that if the fluid level ever gets low they will certainly burn out. They need to be soaked in fluid in order not to overheat.
Right and true... The original Resistor is a 2 Watt 17 Ohm and burn very fast if you use more than 7,2 Volt. For more Voltage a Resistor rated 5 Watt arround 12 Ohm is required.
64
« on: October 18, 2018, 05:25:01 AM »
65
« on: September 26, 2018, 11:24:34 PM »
66
« on: September 11, 2018, 02:45:16 AM »
Hi,
i confirm the option for steering servo is the goal for Famo.
The real Famo have had a wide turning radius arrond 10m.
67
« on: September 05, 2018, 12:03:24 AM »
Hi,
i don´t know about the Motor, possible it´s a low rev Diesel.
Functionality there is a lot possible:
Ramp up/down
the two cal. 50 left/right up/down
Lights
the Crew:
- steering
- two at the Cal. 50
- one in the Front at the ramp....
68
« on: July 22, 2018, 12:49:47 PM »
Hi,
currently state:
69
« on: July 15, 2018, 01:02:25 PM »
Hi,
some "Brasswork":
70
« on: July 11, 2018, 12:16:47 AM »
Wow, nice work! Where did you purchase the second one? Did asiatam have some in stock?
Hi, Asiatam have much Famo´s in Stock...
71
« on: July 10, 2018, 03:20:36 AM »
Hello, Project is still in progress. I build now two Famo!  The second one with 6to Bilstein-Crane..
72
« on: July 04, 2018, 02:20:24 PM »
From the very beginning the intent and design of the TCB was for it to be used with modern, high-channel-count radios. It doesn't even accept standard servo inputs! I don't know of any controller on the market today that can read 16 channels or give so many options for combining channels and functions. To use it with a 6 channel radio is to miss the point, it's like putting grocery cart wheels on a Ferrari. Tell your clients they need to upgrade! It surely can't be an issue of money, this is not a cheap hobby to begin with.
Hi Luke, true words!
73
« on: July 04, 2018, 07:33:54 AM »
Hi,
this is a function of the Transmitter.
On every modern Transmitter
you can assign the switches freely
and create functions easily via mixer like IF THEN.
74
« on: June 06, 2018, 01:04:48 PM »
Hi, this are Hobbywing 18A Bushless .... 
75
« on: June 01, 2018, 12:18:14 AM »
Hi Jurgen, i'm very curious on how your Famo will look like with the electronics crammed in!
Hi, here some Pictures....
Pages: 1 2 3 4 [5] 6 7 8 ... 10
|
Show Posts