Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - morebread

Pages: [1]
1
Open Panzer Help / Re: tamiya mech recoil
« on: May 06, 2020, 02:02:23 PM »
Hi Luke & Jerry,

I adjusted my radio as called out; still no luck on the mech recoil motor not constantly cycling. All other functions still fuction properly as before adjustment of the radio's min-max.

AK



Radio Ready - iBus

---------------------------------------------
FIRMWARE VERSION: 0.93.68 (EEPROM Size: 481)

---------------------------------------------
RADIO INFO - iBus
---------------------------------------------
Stick       Min    Center   Max    Deadband  Reversed
---------------------------------------------
Throttle    988    1500     2011    15        FALSE
Turn        988    1500     2011    15        FALSE
Elevation   988    1500     2011    20        FALSE
Azimuth     988    1499     2011    18        FALSE

Aux Chan.   Min     Max     Type
---------------------------------------------
1           988     2011    Digital
2           988     2011    Digital
3           988     2011    Digital
4           988     2011    Digital
5           1500    2011    Digital
6           1500    1500    Analog
7           1500    1500    Analog
8           1500    1500    Analog
9           1500    1500    Analog
10          1500    1500    Analog
11          IGNORED
12          IGNORED
---------------------------------------------
Channels detected: 14
Channels utilized: 14

---------------------------------------------
MOTOR TYPES
---------------------------------------------
Drive Motors:      Sabertooth Serial
Turret Rotation:   Onboard Motor Driver (A)
Barrel Elevation:  Pan Servo
Mechanical Barrel: Mechanical recoil (Enabled)

---------------------------------------------
DRIVE SETTINGS
---------------------------------------------
Vehicle Type:           Tank
Active Driving Profile: 1
Accel Ramp Enabled:     Yes (Level: 4, Preset: None)
Decel Ramp Enabled:     Yes (Level: 2, Preset: None)
Motor Nudge Enabled:    Yes (5% throttle for 250 ms)
Forward Speed Limited:  No
Reverse Speed Limited:  Yes - 70%
Transmission Type:      Automatic
Shift Time:             0.0 sec
Engine Pause Time:      0.5 sec
Transmission Delay:     0.5 sec
Neutral Turn Allowed:   Yes - 45%
Turn Mode:              3
Track Recoil Enabled:   Yes (Kickback speed 30%, Deceleration factor 8)

---------------------------------------------
TURRET SETTINGS
---------------------------------------------
Turret Rotation Speed Limited:  No
Barrel Elevation Speed Limited: Yes - 12%
Recoil delay:                   No

---------------------------------------------
SMOKER
---------------------------------------------
Smoker output controlled manually

---------------------------------------------
BATTLE INFO
---------------------------------------------
Is Repair Tank?   No
Fire Protocol:    Tamiya
Hit Protocol 2:   Heng Long
Repaired by:      IBU Repair
Send MG IR Code:  No
Accept MG Damage: No
Damage Profile:   Tamiya Spec
Weight Class:     Medium
(6 cannon hits, 5.0 sec reload, 12.0 sec recovery)

---------------------------------------------
SOUND CARD
---------------------------------------------
Sound card: Benedini TBS Mini

---------------------------------------------
FUNCTION TRIGGERS
---------------------------------------------
Turret stick functions: None
Aux Channel  3 - Pos 1 (of 2) -> Function #12  - Machine Gun - Stop
Aux Channel  1 - Pos 3 (of 3) -> Function #16  - Light 1 (Headlights) - Toggle On/Off
Aux Channel  1 - Pos 1 (of 3) -> Function #19  - Light 2 - Toggle On/Off
Aux Channel  5 - Pos 3 (of 3) -> Function #161 - Smoker - Manual Toggle
Aux Channel  3 - Pos 2 (of 2) -> Function #11  - Machine Gun - Fire
Aux Channel  2 - Pos 3 (of 3) -> Function #1   - Engine - Toggle On/Off
Aux Channel  2 - Pos 1 (of 3) -> Function #4   - Transmission - Toggle On/Off
Aux Channel  4 - Pos 2 (of 2) -> Function #7   - Cannon Fire
Aux Channel  4 - Pos 1 (of 2) -> Function #14  - Airsoft/Mech Recoil - Disable

---------------------------------------------
BATTERY
---------------------------------------------
Battery Detected: No
LVC Enabled:      Yes (6.4v cutoff)

---------------------------------------------
BAUD RATES
---------------------------------------------
USB Serial Baud:   115200
Motor Serial Baud: 38400
Aux Serial Baud:   115200
Serial 3 Tx Baud:  38400

---------------------------------------------

2
Open Panzer Help / Re: tamiya mech recoil
« on: April 28, 2020, 12:10:06 PM »
Hi,

Yes, the switch on the mech. recoil is good and functioning. All of the lights ive installed (mg and front light) are fully functioning as intended.

AK

3
Open Panzer Help / Re: tamiya mech recoil
« on: April 21, 2020, 05:19:46 PM »
Hi Like,

Thanks for the response. I only added those 2 functions in an attempt to fix the issue. :-\

The mech recoils were tested in my pershing with the Tamiya Control board and the limit switch functions as they should.

AK

4
Open Panzer Help / tamiya mech recoil
« on: April 21, 2020, 03:33:48 PM »
Hi all,

Hoping to get some advisement on an problem im having difficulty solving. Searched the forum but havent found any info to solve. I have a Tamiya panzer IV with the original Tamiya mechanical recoil unit that the motor cycles continuously the minute i turn on the power. Ive tried multiple settings in the OP config to no avail. I also tried another mech. recoil unit from my tamiya pershing; same thing. Cannon sound and hi intensity flash trigger properly.

AK

FIRMWARE VERSION: 0.93.68 (EEPROM Size: 481)

---------------------------------------------
RADIO INFO - iBus
---------------------------------------------
Stick Min Center Max Deadband Reversed
---------------------------------------------
Throttle 988 1500 2011 15 FALSE
Turn 988 1500 2009 15 FALSE
Elevation 988 1500 2011 20 FALSE
Azimuth 988 1499 2008 18 FALSE

Aux Chan. Min Max Type
---------------------------------------------
1 988 2011 Digital
2 988 2011 Digital
3 1500 2011 Digital
4 1500 2011 Digital
5 1500 2011 Digital
6 1500 1500 Analog
7 1500 1500 Analog
8 1500 1500 Analog
9 1500 1500 Analog
10 1500 1500 Analog
11 IGNORED
12 IGNORED
---------------------------------------------
Channels detected: 14
Channels utilized: 14

---------------------------------------------
MOTOR TYPES
---------------------------------------------
Drive Motors: Sabertooth Serial
Turret Rotation: Onboard Motor Driver (A)
Barrel Elevation: Pan Servo
Mechanical Barrel: Mechanical recoil (Enabled)

---------------------------------------------
DRIVE SETTINGS
---------------------------------------------
Vehicle Type: Tank
Active Driving Profile: 1
Accel Ramp Enabled: Yes (Level: 4, Preset: None)
Decel Ramp Enabled: Yes (Level: 2, Preset: None)
Motor Nudge Enabled: Yes (5% throttle for 250 ms)
Forward Speed Limited: No
Reverse Speed Limited: Yes - 70%
Transmission Type: Automatic
Shift Time: 0.0 sec
Engine Pause Time: 0.5 sec
Transmission Delay: 0.5 sec
Neutral Turn Allowed: Yes - 50%
Turn Mode: 3
Track Recoil Enabled: Yes (Kickback speed 30%, Deceleration factor 8)

---------------------------------------------
TURRET SETTINGS
---------------------------------------------
Turret Rotation Speed Limited: No
Barrel Elevation Speed Limited: Yes - 12%
Recoil delay: No

---------------------------------------------
SMOKER
---------------------------------------------
Smoker output controlled manually

---------------------------------------------
BATTLE INFO
---------------------------------------------
Is Repair Tank? No
Fire Protocol: Tamiya
Hit Protocol 2: Heng Long
Repaired by: IBU Repair
Send MG IR Code: No
Accept MG Damage: No
Damage Profile: Tamiya Spec
Weight Class: Medium
(6 cannon hits, 5.0 sec reload, 12.0 sec recovery)

---------------------------------------------
SOUND CARD
---------------------------------------------
Sound card: Benedini TBS Mini

---------------------------------------------
FUNCTION TRIGGERS
---------------------------------------------
Turret stick functions: None
Aux Channel 4 - Pos 2 (of 2) -> Function #7 - Cannon Fire
Aux Channel 3 - Pos 1 (of 2) -> Function #12 - Machine Gun - Stop
Aux Channel 1 - Pos 3 (of 3) -> Function #16 - Light 1 (Headlights) - Toggle On/Off
Aux Channel 1 - Pos 1 (of 3) -> Function #19 - Light 2 - Toggle On/Off
Aux Channel 5 - Pos 3 (of 3) -> Function #161 - Smoker - Manual Toggle
Aux Channel 3 - Pos 2 (of 2) -> Function #11 - Machine Gun - Fire
Aux Channel 2 - Pos 3 (of 3) -> Function #1 - Engine - Toggle On/Off
Aux Channel 2 - Pos 1 (of 3) -> Function #4 - Transmission - Toggle On/Off
Aux Channel 4 - Pos 1 (of 2) -> Function #14 - Airsoft/Mech Recoil - Disable
Aux Channel 4 - Pos 2 (of 2) -> Function #13 - Airsoft/Mech Recoil - Enable

---------------------------------------------
BATTERY
---------------------------------------------
Battery Detected: No
LVC Enabled: Yes (6.4v cutoff)

---------------------------------------------
BAUD RATES
---------------------------------------------
USB Serial Baud: 115200
Motor Serial Baud: 38400
Aux Serial Baud: 115200
Serial 3 Tx Baud: 38400

---------------------------------------------



5
Show and Tell / taigen king tiger
« on: April 21, 2020, 03:21:43 PM »



Hi all,

Just wanted to share my project. Still needing some weathering, color modulation and pin washes but its pretty close to finished. Pretty happy with how the internals got organized.

I feel fortunate that i was able to snag 2 Open panzer TCBs before HK discontinued them. Really wish a new supplier is found.

Pages: [1]
bomber-explosion