1

TCB Dev / Re: TCB Firmware with Stock Arduino Mega

« on: May 17, 2026, 07:00:41 AM »

I have the escs set up as described and I’ve had good experience with them on other projects (rc ships).

Think you might be right with the battery though. I’m using a NiMH battery because discharge rates haven’t been so important to me. I’ve got a lipo on order and I’ll see if that improves things.

2

TCB Dev / Re: TCB Firmware with Stock Arduino Mega

« on: May 15, 2026, 02:34:42 PM »

Anyone able to help with a track recoil issue on an arduino mega build?

I’m using to radio link 9030 escs which work fine when driving. When I use track recoil I have no issues if only one esc is connected at a time. However, if I connect both then the entire system goes hay wire and the track recoil effect fires on a continuous loop until I reset the system. Any idea what could be causing this?