1

Open Panzer Help / Gunfire sounds have stopped working

« on: January 30, 2020, 01:31:09 PM »

Just come back from a break from tanks, and both of my gunfire s ounds have stopped working! This is using a bendini mini, which was working fine when I last used it.

All of the engine sounds are fine, the gun recoil and flash work as before, just no sound!

I have tried re loading the TCB settings file, updated firmware etc, but to no avail.

I am not really sure where to start looking as its been a while, any suggestions please would be welcome!

Paul

2

Open Panzer Help / IR Doesnt seem to be working

« on: October 01, 2018, 08:42:15 AM »

Hi

I have just finished the upgrade to my Taigen Panther G. Everything except the IR system seems to be working fine.

However, I cannot get anything on the IR side to work. No visible signs of power to the TX LED, and no apparent register of hits from another Taigen IR system.

I have put a voltmeter across the TX pins and on fire, it shows 0.25v ! This seems way too low. I have set the output to Taigen V1, but also accept hits from V2/3

The setup uses the High intensity flash, the standard Taigen apple (I have early with green PCB and late with red PCB) and the standard Taigen TX LED. The Wires have been moved as per your instruction sheet for adding this unit to the OP board.

What is the best way to test this side of the board? What tests do you recommend I do to verify what is/isnt working?

Regards

Paul