Open Panzer
Open Panzer Help & Info => Open Panzer Help => Topic started by: itsjjg123 on December 06, 2017, 10:52:38 PM
-
I'm having an issue with the Max Speed setting on the Smoker control. I tried lowering the max speed and now the smoker reaches full speed before full throttle and then cuts off, instead of limiting the full throttle speed.
For example I set the max speed to 80% and when I move the throttle stick up to 80% the smoker is running at max speed, and when I push the stick up a little further the smoker cuts off. No smoker at all for the last 20% of the throttle travel.
Am I missing something in the programming? Is anyone else having this issue? Any thoughts on the subject would be helpful.
-
This sounds like a bug to me, probably introduced during one of the recent updates. I will take a look at it but it might not be right away, I've been slammed with work and other stuff.
In the meantime can you post the OPZ file you're using so I can replicate your settings exactly?
-
Thanks for the quick reply. Here's the OPZ file.
-
I can confirm it's a bug. The smoker should work fine for now if you leave max speed at 100%.
Like I say, it might be this weekend or even next week before I can fix this. Just wanted you to know you weren't going crazy and your board isn't defective. Just needs a software fix.
-
Good to here, I was a little worried about it being the board. Thanks for the help.
-
This issue should be fixed with v0.92.15 of TCB firmware, which I have just posted.
You do not need to update OP Config for this one, just flash new firmware to TCB.
-
Thanks for the fix. It works perfectly.