Show Posts
1
Open Panzer Help / Motors swapped and ligths don't work
« on: December 15, 2018, 07:41:20 PM »
Hi, Im getting crazy with my tank.
Finally I solved some things buy I still have problems and I need help because I dont understand what is the problem.
My tank is a Tigen full metal Early and I connected the taigen sound board.Motor are stock, the old ones.
Receiver is a Frysky compatible irange Fli14+ connected via ibus in the top pins.
Smoker DKLM V3 disconnected now.
Frysky FS-i6s , Mode 1 with spring
X2 ESC HPI , Reverse function desactivated. I think dont have brake, but not sure.
Motors problem.
In radio pahe all is OK and detect the movements like I want.
Ligth In board work rigth.
Nothing reverse, all sould work properly.
Nope, A motor work inverted to the other. I know left motor is in right side.
No way get it work. The left one work rigth, and I decide swap wires in the motor. Now the motors go in the same way but to go foward mechanicaly, the board and the configurator must show Im in reverse all is swapped. No other way than swap speeds,constraints etc, but now the problem is turning while drive is OK, but if I turn in 0 speed, is reversed, its crazy.
Lights: No one ligth work, there is current, 5V, but they dont work, they need a resistance or something, in the wiki dont tell anythind about modifications in the lights, and I connected straight foward.
Excuse my poor english
Finally I solved some things buy I still have problems and I need help because I dont understand what is the problem.
My tank is a Tigen full metal Early and I connected the taigen sound board.Motor are stock, the old ones.
Receiver is a Frysky compatible irange Fli14+ connected via ibus in the top pins.
Smoker DKLM V3 disconnected now.
Frysky FS-i6s , Mode 1 with spring
X2 ESC HPI , Reverse function desactivated. I think dont have brake, but not sure.
Motors problem.
In radio pahe all is OK and detect the movements like I want.
Ligth In board work rigth.
Nothing reverse, all sould work properly.
Nope, A motor work inverted to the other. I know left motor is in right side.
No way get it work. The left one work rigth, and I decide swap wires in the motor. Now the motors go in the same way but to go foward mechanicaly, the board and the configurator must show Im in reverse all is swapped. No other way than swap speeds,constraints etc, but now the problem is turning while drive is OK, but if I turn in 0 speed, is reversed, its crazy.
Lights: No one ligth work, there is current, 5V, but they dont work, they need a resistance or something, in the wiki dont tell anythind about modifications in the lights, and I connected straight foward.
Excuse my poor english