8
« on: November 19, 2017, 12:51:16 PM »
Good afternoon. First congratulate Luke for this great job. I ordered some scout pcb (rev.10) to seed, soldered the components with a hot plate as recommended. Burned the 328p atmega through the isp using an arduino nano and the arduino ide as (arduino as isp) then with the same arduino as cable ftdi and uploaded the program with open panzer. I think it went up well since it did not No error message. But a doubt arises when I connect the scout to the tcb by the serial port following the letters of the tcb and the scout (tx-rx- gnd) these are not in the same order on the two plates. as the plates mark, the red LED lights up intermittently and does not respond to any order of the control. but if I connect the cables in the same order as shown in the tcb, the blue led lights steadily, but does not respond to the movement of the stick, but if I move a wheel of the station to which I am assigned in a position the lights and in another cannon shot. When I put the firing position (if I have the airsoft gun disconnected) one of the engines moves a little towards a direction. If I have the gun connected it shoots and at the same time tries to move the engine but much less than if it is not connected and when this happens the blue led of the scout turns off and the red one turns on 4 times. I have to say that I do not have sbus or ibus station. if not a ppm adapter that transforms the signal from my standard receiver to ppm. the movement of the tower works and the lights on and off. if you can tell me if it's a problem with the station or the scout. a greeting sorry for the billet