1

Open Panzer Help / Re: Smoke problem

« on: March 29, 2021, 12:07:44 PM »

I'm sure my readings are correct but I won't risk any soldering so I think I'll just have to accept how it is. Not a problem though the rest of the board works great and I'll just find another way to control the smoker. Thanks for your help.

2

Open Panzer Help / Re: Smoke problem

« on: March 28, 2021, 01:38:29 PM »

Hi Luke

The volts stay at 0 all the time, I have attached the settings for my tcb for you to have a look at. I've tried various triggers, these are the last ones I tried.

3

Open Panzer Help / Re: Smoke problem

« on: March 26, 2021, 03:09:51 PM »

Hi Luke

I've tried the settings but it's still the same, it won't turn off. Here's a picture of my board, it looks ok.

4

Open Panzer Help / Re: Smoke problem

« on: March 21, 2021, 03:31:34 PM »

Hi Luke, I tried your settings but no change. I get about 4v when plugged in to my pc and 12v from the battery as soon as its connected. I have just been plugging in the smoke element as I want to run the fan from the aux port. If this can't be fixed is there another way to power the smoker for instance with a heng long proportional unit. Basically I just want full smoker power (with preheat ideally) on engine start for a few seconds and then shut the smoker down until next engine start. By the way the board has a 12v supply and the motors are 24v, it's a 1/6 scale tank.

5

Open Panzer Help / Smoke problem

« on: March 20, 2021, 01:56:55 PM »

Hi

When I power up the TCB the smoke output goes straight to full battery power and nothing I try makes it adjustable or turn off. I might have shorted out the two pins when I was checking the volt output so could this have caused damage to the smoker circuit. Everything else on the board works fine