1. Can the Tank be programmed to shut off sound when the TX is turned off? Right now it continues to run. When the Tamiya TX is shut off the tank shuts off too. I have it programmed to start with the turret stick (LF).
2 Can the IR indicators lights on the TBU be shut off so not to blink every time the IR shot is ready to fire? This is a nice feature, I just dont want it to be confused with a hit. I know it only flashes short and quick, compared to longer and more steady flash after a hit.
3. Is the "learn" button not used on the TBS with the TCB? On the BARC it was used to synchronize the sound to the movement of the tank. Right now it seems the sound moves too quickly and does not seem to be in sync with the movement of the gearboxes.
I am just using one of the TBS downloaded tank sounds so no incoming hit sounds or destroyed tank sounds. I will have to make my own sounds, unless someone would like to share theirs.
Ill try and load the destroyed sounds tonight. I am not sure how to load them with the TBS downloaded engine sounds. Ill do some more reading. I have some older sounds from my BARCs too, Ill see if they can be loaded. They were before the TBS updates though so not sure if they will still work.
No luck on the tank shut down when TX is turned off. I checked in the TX and all channels are failsafe "off".When I shut off the TX, the led flashes on the RX, but engine still sounds and I also found will continue to drive if I shut it off while driving. The only way to stop or shut it off is too disconnect RX from TCB. I checked prop settings again, and they are correct. If I first turn the TCB on, then all lights flash indicating no radio signal until I turn the TX on. I tried checking during snoop and its not reading any radio loss. It reads nothing when the TX is turned from on to off.
I also noticed the snoop does not read any turret stick movements.
I also noticed turret sounds eliminate cannon fire. If I rotate turret or elevate, and fire cannon at the same time, the cannon makes no sound.
I had figured out the "off" settings. I change the throttle to zero, actually all channels failsafe to no movement. At least the tank will stop now. I am still trying to figure out a way to shut off sound since I have the engine start up and shut down on the left stick lower left corner.
I was also trying to get the destroyed sound to play a few seconds before it shuts the tank off. Right now as soon as the final hit is taken, it shuts off the tank.