I have been going through the sound section and a tad unsure trying to compare what I am currently
doing with the TCB set up.
I am familiar with the TBS/BARC set up and essentially want to see if I can still do all of what
I am currently doing. I hope this will all makes sense but as you are familiar with the BARC
and perhaps it is a simple as a "yes"
The BARC has Position 1 on right stick up/ throttle.
The left stick has similar positions as you have on the TCB
At the moment I have the engine start which is R stick pos. 1 flip up doing a cold crank
which turns the system on but no engine start up (allowing smoker to warm up)
Cannon has to be position 4
MG has to be position 5
Turret has to be 6
Elevation has to be 7
I activate the engine start up/shut down with the left stick user definable position 8
The other user definable positions of 10 and 9 I am using as track noise or cold start or some other sound such as a
rev or slow drop in idle (or music etc) I can change it around in the parameter section as all the sounds are saved in the sound file.
Some of these sounds like turret are set to "dynamic in dynamic loop dynamic out" Cannon" normal" or "mute" for an engine rev or music sound.
My question is essentially would all of this remain the same if I wanted to keep it all
on the two sticks at first and eventually moving some of these sounds or sound/functions
to switches or add additional sounds to switches?
Sorry for the long question but perhaps it will also help answer this question or something similar somebody else may have.