Show page

Menu

Search

Random Fact

This Wiki has 49 million pages and took 10 years to write!
(Well, close...)

If you like the Open Panzer project we accept donations!

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revision Both sides next revision
wiki:tcb:tcbinstall:servorotation [2017/07/18 21:01]
opadmin [Turret/Barrel Rotation Servo] 		wiki:tcb:tcbinstall:servorotation [2017/07/18 21:01]
opadmin [Turret/Barrel Rotation Servo]
Line 8: Line 8:
  
 {{ wiki:rotationservo_dip.png?direct|Turret Rotation Servo setup menu dipswitch settings}} {{ wiki:rotationservo_dip.png?direct|Turret Rotation Servo setup menu dipswitch settings}}
-All the information for setting up the end-points and reversing on this type of servo are the same as for the barrel elevation servo, so be sure to [[wiki:tcb:tcbinstall:servobarrel|read that page for more]]. To enter the special setup menu for the rotation servo, plug your servo into RC output 3 on the TCB. Also set Dipswitch #3 on the TCB to the Off position and Dipswitch #4 to the On position. Then press and hold the input button for two seconds to enter the setup menu. To exit the menu, press the INPUT button again briefly. It is recommended to connect your TCB to your computer and view the OP Config console in Snoop mode while executing special menus for the extra detail this will provide. +All the information for setting up the end-points and reversing on this type of servo are the same as for the barrel elevation servo, so be sure to [[wiki:tcb:tcbinstall:servobarrel|read that page for more]].  
 + 
 +To enter the special setup menu for the rotation servo, plug your servo into RC output 3 on the TCB. Also set Dipswitch #3 on the TCB to the Off position and Dipswitch #4 to the On position. Then press and hold the input button for two seconds to enter the setup menu. To exit the menu, press the INPUT button again briefly. It is recommended to connect your TCB to your computer and view the OP Config console in Snoop mode while executing special menus for the extra detail this will provide. 
  
 The video below shows the setup of the barrel elevation servo but the procedure is the same for the turret rotation servo.   The video below shows the setup of the barrel elevation servo but the procedure is the same for the turret rotation servo.  
wiki/tcb/tcbinstall/servorotation.txt · Last modified: 2017/07/18 21:28 by opadmin
Show pageSitemap
AdminBack to top