Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
wiki:tcb:tcbinstall:servobarrel [2016/03/26 04:27]
opadmin [Barrel Elevation Servo]
wiki:tcb:tcbinstall:servobarrel [2016/03/26 04:27] (current)
opadmin [Barrel Elevation Servo]
Line 10: Line 10:
   
 {{ wiki:​barrelservo_dip.png?​direct|Barrel Elevation Servo setup menu dipswitch settings}} {{ wiki:​barrelservo_dip.png?​direct|Barrel Elevation Servo setup menu dipswitch settings}}
-If you do select a servo for barrel elevation (either regular RC Output or using the Pan Effect), you may also want to set custom end-points on your servo travel. But because the radio'​s turret stick is used for more than direct control of the turret motors, it is not practical to use the transmitter'​s end-point settings to do so. Never fear, you can do it much more easily using the TCB's servo-setup menu. The TCB has four special menus chosen by the position of dipswitch #3 and #4. To select the Barrel Elevation Servo setup menu set both dipswitch #3 and #4 to On. Then to enter the menu, press and hold the INPUT button on the TCB for two seconds. To exit the menu, press the INPUT button again. ​+If you do select a servo for barrel elevation (either regular RC Output or using the Pan Effect), you may also want to set custom end-points on your servo travel. But because the radio'​s turret stick is used for more than direct control of the turret motors, it is not practical to use the transmitter'​s end-point settings to do so. Never fear, you can do it much more easily using the TCB's servo-setup menu. The TCB has four special menus chosen by the position of dipswitch #3 and #4. To select the Barrel Elevation Servo setup menu set both dipswitch #3 and #4 to On. Then to enter the menu, press and hold the INPUT button on the TCB for two seconds. To exit the menu, press the INPUT button again briefly
  
 While in this menu use the barrel elevation stick to adjust the end points. Use the steering stick to select which end-point you are adjusting. And use the throttle stick to reverse the servo'​s movement. ​ While in this menu use the barrel elevation stick to adjust the end points. Use the steering stick to select which end-point you are adjusting. And use the throttle stick to reverse the servo'​s movement. ​
wiki/tcb/tcbinstall/servobarrel.txt ยท Last modified: 2016/03/26 04:27 by opadmin