Differences
This shows you the differences between two versions of the page.
Both sides previous revision
Previous revision
|
Last revision
Both sides next revision
|
wiki:tcb:tcbinstall:servobarrel [2016/03/26 04:26] opadmin [Barrel Elevation Servo] |
wiki:tcb:tcbinstall:servobarrel [2016/03/26 04:27] opadmin [Barrel Elevation Servo] |
| |
{{ wiki:barrelservo_dip.png?direct|Barrel Elevation Servo setup menu dipswitch settings}} | {{ wiki:barrelservo_dip.png?direct|Barrel Elevation Servo setup menu dipswitch settings}} |
If you do select a servo for barrel elevation, you may also want to set custom end-points on your servo travel. But because the radio's turret stick is used for more than direct control of the turret motors, it is not practical to use the transmitter's end-point settings to do so. Never fear, you can do it much more easily using the TCB's servo-setup menu. The TCB has four special menus chosen by the position of dipswitch #3 and #4. To select the Barrel Elevation Servo setup menu set both dipswitch #3 and #4 to On. Then to enter the menu, press and hold the INPUT button on the TCB for two seconds. To exit the menu, press the INPUT button again. | If you do select a servo for barrel elevation (either regular RC Output or using the Pan Effect), you may also want to set custom end-points on your servo travel. But because the radio's turret stick is used for more than direct control of the turret motors, it is not practical to use the transmitter's end-point settings to do so. Never fear, you can do it much more easily using the TCB's servo-setup menu. The TCB has four special menus chosen by the position of dipswitch #3 and #4. To select the Barrel Elevation Servo setup menu set both dipswitch #3 and #4 to On. Then to enter the menu, press and hold the INPUT button on the TCB for two seconds. To exit the menu, press the INPUT button again. |
| |
While in this menu use the barrel elevation stick to adjust the end points. Use the steering stick to select which end-point you are adjusting. And use the throttle stick to reverse the servo's movement. | While in this menu use the barrel elevation stick to adjust the end points. Use the steering stick to select which end-point you are adjusting. And use the throttle stick to reverse the servo's movement. |