Differences
This shows you the differences between two versions of the page.
Both sides previous revision
Previous revision
|
|
wiki:tcb:tcbinstall:motors:serialmotor [2019/09/05 20:27] opadmin [Scout ESC Setup] |
wiki:tcb:tcbinstall:motors:serialmotor [2020/01/08 17:24] (current) opadmin [Sabertooth - Serial Controllers] |
| |
=== Sabertooth baud rate settings === | === Sabertooth baud rate settings === |
The Sabertooth 2x5 doesn't need anything more than the dipswitches shown above - it can automatically detect the correct baud rate to use. The Sabertooth 2x12, 2x25 and 2x60 need to have their baud rates set with a special utility provided in OP Config, see the [[wiki:opconfig:tabs:misc#sabertooth_baud_rate_tool|Misc tab]] for more. The Sabertooth 2x32 is a special case and you must set the baud rate on it with the DEScribe software provided by Dimension Engineering. | The Sabertooth 2x5 doesn't need anything more than the dipswitches shown above - it can automatically detect the correct baud rate to use. The other Sabertooth models need to have their baud rates set with a special utility provided in OP Config, see the [[wiki:opconfig:tabs:misc#sabertooth_baud_rate_tool|Misc tab]] for more. You can also change the baud rate of some models using the DEScribe software provided by Dimension Engineering. |
| |
==== Sabertooth - R/C Controllers ==== | ==== Sabertooth - R/C Controllers ==== |