Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
wiki:tcb:tcbinstall:boardlayout [2016/05/11 03:24]
opadmin [Left Side]
wiki:tcb:tcbinstall:boardlayout [2018/07/21 17:08]
opadmin [Left Side]
Line 16: Line 16:
 This screw terminal is where you attach battery power to the TCB. It is reverse-polarity protected. The TCB can accept any voltage from 7-15 volts. See the [[wiki:tcb:tcbinstall:power|Power Supply]] page for more information.  This screw terminal is where you attach battery power to the TCB. It is reverse-polarity protected. The TCB can accept any voltage from 7-15 volts. See the [[wiki:tcb:tcbinstall:power|Power Supply]] page for more information. 
  
-{{ wiki:dualconnector.jpg?direct&400|Radio Connector}}+{{ wiki:dualconnector.jpg?direct&480|Radio Connector}}
 ===Radio=== ===Radio===
-The TCB actually has dual radio connectors - one is located on the top of the board and the other on the bottom. The top connector is used for PPM or iBus receivers, and the bottom connector for SBus receivers (the bottom connector inverts the signal before feeding it into the processor). The easiest way to connect your receiver is with a standard male-to-male servo extension cable. The TCB automatically detects the type of receiver attached. As a rule, PPM receivers can have up to 8 channels, iBus supports up to 14 channels, and SBus receivers provide up to 16 channels. See the [[wiki:tcb:tcbinstall:rx|Receiver]] page for more information on receiver types, and the [[wiki:tcb:tcbinstall:rx:radioguide|Radio Guide]] for some recommendations on radio systems.+The TCB actually has dual radio connectors - one is located on the top of the board and the other on the bottom. The top connector is used for PPM or iBus receivers, and the bottom connector for SBus receivers (the bottom connector inverts the signal before feeding it into the processor). The easiest way to connect your receiver is with a standard male-to-male servo extension cable. The TCB automatically detects the type of receiver attached. As a rule, PPM receivers can have up to 8 channels, iBus supports up to 14 channels, and SBus receivers provide up to 16 channels. See the [[wiki:tcb:tcbinstall:rx|Receiver]] page for more information on receiver types including recommendations for receivers and radios.
 ===== Right Side ===== ===== Right Side =====
 ===USB=== ===USB===
wiki/tcb/tcbinstall/boardlayout.txt ยท Last modified: 2021/04/07 01:12 by opadmin