Differences
This shows you the differences between two versions of the page.
Both sides previous revision
Previous revision
|
|
wiki:opconfig:tabs:radio [2020/07/25 20:20] opadmin [General Information] |
wiki:opconfig:tabs:radio [2020/07/25 20:21] opadmin [Radio Setup] |
</li> | </li> |
| |
<li><b>Aux Channel Positions:</b> If an Aux channel is specified as <b>Analog</b>, the Position setting will be hidden because an analog channel has an essentially unlimited number of positions. In the example above, Aux channels 1 & 2 are Analog so have no Position setting available. But if your Aux channel is a switch, or in other words, a <b>Digital</b> channel, you need to tell the TCB whether it is a 2-position switch or a 3-position switch. Support for switches with greater number of positions is not presently implemented. It is also important to remember that a 3-position switch will have 3 positions, and a 2-position switch will have 2 positions. But of course! That sounds very logical. However it can cause some confusion when we look at the current switch position in item #9 below. | <li><b>Aux Channel Positions:</b> If an Aux channel is specified as <b>Analog</b>, the Position setting will be hidden because an analog channel has an essentially unlimited number of positions. In the example above, Aux channels 1 & 2 are Analog so have no Position setting available. But if your Aux channel is a switch, or in other words, a <b>Digital</b> channel, you need to tell the TCB how many positions it has (2-9). It is also important to remember that a 3-position switch will have 3 positions, and a 2-position switch will have 2 positions. But of course! That sounds very logical. However it can cause some confusion when we look at the current switch position in item #9 below. |
</li> | </li> |
| |