Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
wiki:opconfig:gs:rwdevice [2016/01/28 03:21] opadmin [Reading and Writing Settings on the TCB] |
wiki:opconfig:gs:rwdevice [2016/03/18 23:11] opadmin [Reading and Writing Settings on the TCB] |
||
---|---|---|---|
Line 5: | Line 5: | ||
====== Reading and Writing Settings on the TCB ====== | ====== Reading and Writing Settings on the TCB ====== | ||
- | {{ wiki: | + | {{ wiki: |
While connected, you can read settings //from// the TCB using the button with the green arrow pointing down, or you can write settings //to// the TCB by using the button with the blue arrow pointing up. While reading or writing the **Progress Bar** will indicate progress, and when complete, the **Info Area** will let you know if the operation was successful. | While connected, you can read settings //from// the TCB using the button with the green arrow pointing down, or you can write settings //to// the TCB by using the button with the blue arrow pointing up. While reading or writing the **Progress Bar** will indicate progress, and when complete, the **Info Area** will let you know if the operation was successful. | ||
When you first open the OP Config program all the settings you see are initialized to some default values. These probably will not match the settings on your TCB. For that reason, if you just want to modify a few settings on the TCB, it is a good idea to **// | When you first open the OP Config program all the settings you see are initialized to some default values. These probably will not match the settings on your TCB. For that reason, if you just want to modify a few settings on the TCB, it is a good idea to **// | ||
- | and only then **// | + | and only then **// |
- | If the **Progress Bar** halts midway through the operation, and after five or ten seconds has still not resumed, an error has occurred and the operation is not going to complete. In that case, click the **Connect** button (which should now read **Disconnect**). Then re-connect to the TCB and try again. | + | So again, it is always a good idea to read in all settings from the TCB first, then make changes in OP Config, and only then write the settings back to the TCB. |
+ | |||
+ | If the **Progress Bar** halts midway through the operation, and after five or ten seconds has still not resumed, an error has occurred and the operation is not going to complete. In that case, click the **Disconnect** | ||