Registration Notice

Due to increased spam, forum registration must be manually approved by a moderator! Please see this post for instructions.

*

Offline Chi-el

  • 17
    • View Profile
  • Netherlands
Re: High speed tracked vehicle....something different
« Reply #15 on: September 13, 2021, 10:51:11 AM »
Hi Luke,

Got the crystals soldered on and was deeply hoping the board to light up, but it still gives the exact same message as before  :o.
Tried it again with different power sources, both USB and external 15V. Does the USBasp require anything else done in preparation other then the driver and jumper switch to 5V?
I have no other clue on what to try next  :-\

*

Offline LukeZ

  • 1130
    • View Profile
  • Kansas
Re: High speed tracked vehicle....something different
« Reply #16 on: September 15, 2021, 01:35:52 PM »
Hi Chi-el, sorry you're having all these problems, and sorry also for the slow reply.

At this point we are back to the basics. First of all, make doubly sure that you are connecting the ISP cable to the board correctly. You might take a photo of the orientation you've been using so I can double check.

You could also try buying a different USBASP (maybe yours is defective).

If you have an off-the shelf Arduino board lying around, you could also try using the USBASP to put a bootloader on that. Open the Arduino IDE, in the Tools menu select your Arduino Board type to match whatever kind of Arduino you have, under Programmer select USBASP, and then select Burn Bootloader (Arduino already knows the stock bootloaders for all boards). Of course your off-the-shelf Arduino will already have a bootloader on it, you'll just be overwriting it with the same thing, but if this works it would tell us your USBASP is functioning, which might lead us to think there is still something wrong with your TCB boards.
NO SUPPORT THROUGH PM - Read why
Need a forum account? Read here
Open Panzer FAQs

 

bomber-explosion