Downloads

Tank Control Board (TCB)

OP Config
v0.92.14
12/3/2017

OP Config Windows Installer

For Developers

GitHub Repository
Download .zip
Download .tar.gz
Release Notes

USB Drivers for TCB

FTDI VCP - FTDI Virtual COM Port (VCP) drivers
It is recommended you download and run the setup executable version, which is not immediately apparent on the FTDI page - it is in the Comments column of the table you will see there. Check out the USB Drivers page in the Wiki for complete driver installation instructions with photos.

TCB Firmware
v0.92.15
12/10/2017

Compiled hex
(Most users won't need this hex file, just use OP Config to check for new firmware)

For Developers
GitHub Repository
Download .zip
Download .tar.gz
Release Notes

TCB Mk 1
Hardware
Rev 23
12/25/2016

Scout ESC (dual motor controller)

Scout Firmware
v0.90.03
3/11/2017

Compiled hex

For Developers
GitHub Repository
Download .zip
Download .tar.gz
Release Notes

 
Scout Hardware

Rev 11
10/30/2017
The only change in Revision 11 of the Scout ESC is that the motor driver chips are changed from the VNH2SP30 (now obsolete) to their replacements, the VNH5019. These chips have the same specifications as the old ones except they can handle input voltages up to 24 volts as opposed to 16 volts. The new chips have different pin orders so some slight re-routing has been done, therefore Rev 11 and 10 PCBs and stencils are not compatible with each other. Otherwise all components remain the same.

Obsolete

Rev 10
3/5/2017
NOTE! Revision 10 of the Scout ESC calls for the now obsolete VNH2SP30 motor driver ICs. This information is kept here only for reference for those who have already begun builds, new builds should use Rev 11 (above) with the new motor driver chips. PCBs and stencils are not compatible between Rev 10 and 11.

 

Sound Card (still in beta-testing)

For Testers

Please study the ReadMe file at the GitHub Repository for information on how to get started with this design. It is presently in beta-testing and not only must you build your own board to use it, you must also be able to load firmware using the Arduino IDE.

Ongoing discussion thread
GitHub Repository
Download .zip
Download .tar.gz

 
Sound Card Hardware
Rev 1
4/10/2017

Accessories

Tamiya Adapters
MOSFET Switch
LED Current Limiters