0.93.76
6/4/2023

Release Notes
---------------------------------------------------------------------------------------------------------
- The "flicker lights on engine start" effect has been modified. Because the Headlight output (Light 1) 
  can not be adequately manipulated, we have replaced it with the Aux Light output. If you intend to use this
  effect you will want to use the Aux Output for your headlights instead of the Light 1 output. This will require
  assigning the Aux Output on and off functions to a trigger. As a reminder, the flicker light effect is intended
  to create the impression that the headlights/brakelights on your model are experiencing intermittent voltage
  during the time that the engine is being started. This is something that might have been seen on WWII-era tanks. 
  For the effect to be active, you must: 
  * Select the "Flicker lights during engine start" option on the "Lights & IO" tab of OP Config.
  * Specify a "Transmission Engage Delay" time on the "Driving" tab of OP Config. You should set this delay
    equal to the length of time of your engine startup sound. When the engine is started, this delay begins, 
	your engine start sound is played, the transmission will not be engaged (the model can not be moved), and
	the LEDs connected to the Aux output and Brake light outputs will flicker.
  * Of course, the lights will only flicker if they were turned on before the engine start began. 
  * When the "Transmission Engage Delay" has expired, your engine start sound should have also completed. At this
    time the transmission will automatically be engaged (allowing you to beging driving), and the Aux Output and 
	Brake Lights will return to full brightness. 
- IMPORTANT NOTE: Changes in this release will cause all EEPROM settings to be reverted to default after 
  the firmware is flashed. It is advised to save an OPZ file of your settings before updating the firmware.