0.93.75
5/22/2023

Release Notes
---------------------------------------------------------------------------------------------------------
- Added an optional effect that will blink the headlights and brake/running lights on engine startup. Certain 
  conditions must first be met: The user needs to select "Blink Headlights during Engine Start" on the 
  "Lights & IO" tab of OP Config. They also need to specify a "Transmission Engage Delay" time on the "Driving" 
  tab of OP Config. The flickering effect will last for that length of time, which should be set to match the 
  length of your engine start sound. Finally, it will of course only be visible if, prior to starting the engine, 
  the headlights were already on, or in the case of brake/running lights one of those were already on (the only 
  way for the brake lights to be on prior to engine start is if the user has checked the 
  "Brake Lights On when Stopped" option in OP Config). 
- The flickering effect will not be identical for the headlights as for the brakelights, although they will
  follow each other in intensity. But the headlight output on the TCB can not be dimmed and therefor it is only
  able to be turned on or off. The brake lights can be dimmed so their effect will be a little less abrupt.
- An effect has also been added to the smoker that will attempt to create several "puffs" of smoke on engine
  startup. This effect is always active and can not be modified through OP Config. However for most smoker
  designs nothing is likely to be visible since the effect will be over before the heating element has time
  to generate smoke. An exception would be for those using "Separate Heat & Fan" outputs and who have 
  specified a "Preheat time" on the "Driving" tab of OP Config. 
- IMPORTANT NOTE: Changes in this release will cause all EEPROM settings to be reverted to default after 
  the firmware is flashed. It is advised to save an OPZ file of your settings before updating the firmware.