0.93.63 10/7/2019 Release Notes --------------------------------------------------------------------------------------------------------- - Add the ability to read up to 12-position RC switches (previous maximum was 6 positions) - Added functionality to skip the smoker pre-heat engine start delay with a hot-start setting. If the engine is being re-started within the specified hot-start time since the last engine shutdown, the pre-heat will be skipped. The idea here is that the heating element would have retained enough heat within this short time that no pre-heat is necessary. HOWEVER, the user setting is not presently enabled in OP Config as in testing we find that heating elements cool off very quickly and therefore this feature is not likely to be useful. The functionality now exists but it is not enabled. - Further enhancements to the experimental smoker object. - IMPORTANT NOTE: Changes in this release will cause all EEPROM settings to be reverted to default after the firmware is flashed. It is advised to save an OPZ file of your settings before updating the firmware.